For rapid coating removal when going to bare metal. Some substrate is removed which serves as an anchoring pattern for the new applied coatings.

2” Die Grinder Roloc Abrasive Discs

815.224 - 2” 24 grit (very agressive)
815.236 - 2” 36 grit (contractor’s choice)
815.250 - 2” 50 grit (all purpose)
815.280 - 2” 80 grit (finishing)
815.2120 - 2” 120 grit (ultra light or composites)

3” Die Grinder Roloc Abrasive Discs

815.324 - 3” 24 grit (very agressive)
815.336 - 3” 36 grit (contractor’s choice)
815.350 - 3” 50 grit (all purpose)
815.380 - 3” 80 grit (finishing)

4” Floating Bullnose Roloc Abrasive Discs

815.436 - 4” 36 grit (contractor’s choice)
815.460 - 4” 60 grit (all purpose)
815.480 - 4” 80 grit (finishing)

4.5” Sander 7/8” Center Hole Abrasive Discs

815.9424 - 4.5” 24 grit (very agressive)
815.9436 - 4.5” 36 grit (contractor’s choice)
815.9450 - 4.5” 50 grit (all purpose)
815.9480 - 4.5” 80 grit (finishing)

7” Grinder 7/8” Center Hole Abrasive Discs

815.7424 - 7” 24 grit (very agressive)
815.7436 - 7” 36 grit (contractor’s choice)
815.7450 - 7” 50 grit (all purpose)
815.7480 - 7” 80 grit (finishing)

Coated Abrasives Back-Up Pads

141.002 - 2” and 3” Mandrel back-up pads
825.002 - 2” Roloc back-up pad
825.003 - 3” Roloc back-up pad
825.004 - 4” Roloc back-up pad
825.008 - 4.5” Coated abrasive conversion kit
200.425 - 4.5” Back-up pad, coated abrasive & Rip disc.
500.071 - 2” Center nut
500.153 - 7” Coated abrasive back-up pad
200.016 - 7” Back-up pad (Rip disc)

The DescoRip Disc

A 16 grit open-faced grinding disc. Especially effective for the removal of coatings on concrete. Diamond discs, when used to do edge work, tend to polish aggregates. The DescoRip disc leaves the same edges with a roughen surface ready for a new coating application. Approximately two hours of continuous use on concrete surfaces. They can also be used on stubborn coatings on metal surfaces. The DescoRip with all of its advantages is also value priced.